Trijicon bright and tough night sights are three-dot iron sights that increase night-fire shooting accuracy by as much as five times over conventional sights. Trijicon Bright & Tough(TM) Night Sights are three-dot iron sights that increase night-fire shooting accuracy by as much as five times over conventional sights. The SA04 is for guns made before Novak sights (before late 1989). You might also try S&W themselves, as they once made this sight with those dots for the stainless guns, I believe. The SA04 is for guns made before Novak sights (before late 1989). Description: Trijicon Smith And Wesson Bright And Tough Night Sights. You can also paint your real blade using something like Testor's enamel paint, which may be all you need for your purposes.actually I have seen guys use "White out" for this if they only wanted a temporary paint job done in white.works fairly well for one range session, and it may be enough for you to see if you want something more permanent or a different color, or prefer it like it is now.īrownells may have something, but when I looked, all I could find was the standard black sight just as you have now. I agree that is far too much money to get a couple of dots! Consider that what you want to focus on is the front sight, not the rear.anything like dots or Aztec Thunder Gods or suchlike that draws your eye to the rear sight is actually counterproductive for good shooting, although it may.and I do not necessarily agree with this line of thought.be a bit faster to line the sights up for coarse, close range shots, the dots actually tend to act against more precise shot placement at all ranges.which is why all Bullseye shooters used nothing except sharp edged, flat black pistol sights for decades.and still do if they don't use optics.no dots there!
#SMITH AND WESSON 915 NIGHT SIGHTS SERIES#
The older S&W 915 / 411 series guns are actually very decent pistols for the $$$ assuming you have no gripes with the standard DA/SA operation.
Should you wish to change the front sight, it is a standard S&W model and cut, so this is not a problem. If you do not have the vise or a brass punch, pay a few bucks more and let a good gunsmith do it for you.you'll be glad you did. Front Sight for Smith and Wesson J-Frame Barrel 2.1 inch or Less Except 38 Bodyguard 45.40. Doing this will take something like a padded vise, a brass punch and a decent sized hammer. Front Sight for Smith and Wesson 617, 647, 648 Revolver 45.40. The sight is a direct friction fit in the dovetail, but also retains the springs and plungers for the magazine safety and firing pin saftey in place, so you must be careful to make sure you don't loose them when driving it out of the slot. The newer M410 now uses a polymer cheapo knockoff of the Novak rear, but I have no idea if it can be replaced directly with the Novak. Smith & Wesson 915 9mm Para Smith & Wesson, Pistolen, Handfeuerwaffen. Thus any rear sight that is made to fit the Models 39/59 or fixed sight versions of the 439/459 and 639/659 should work. Backed by Smith & Wesson’s Lifetime Service Policy.If I recall correctly, the 411, like the older 915.now 910.pistols uses the older S&W rear sight and sight dovetail cut.from back before the Novak rear sights were added. Striker-fired for short consistent trigger pull, every time.18 degree grip angle for natural point of aim.
#SMITH AND WESSON 915 NIGHT SIGHTS FULL#
Introducing the M&P9 Shield with Night Sights, A slim, concealable and lightweight design combined with the proven and trusted features found in the M&P Pistol Series. America’s favorite carry conceal pistol is now ready for night time.
0 kommentar(er)
